Mecer 2000VA /1600W ON-LINE UPS (with AVR,Monitoring Software + Cable & Built-in Surge Protection) - Black

Features

True double-conversion online UPS

Wide input voltage range (110-300 VAC)

Input power factor correction 0.99

Output power factor 0.8

Converter mode available

ECO mode operation for energy saving (only available for 1-3KVA)

Generator compatible

Smart SNMP works well with either USB or RS-232 together (SNMP NETWORK CARD need to be purchased separately)

Back Time (Minutes)

25% Load 400W: 21 minutes

50% Load 800W: 7 minutes

75% Load 1200W: 4 minutes

100% Load 1600W: 2 minutes

Note:

Data given are the average values, not the minimum values.

A UPS is not designed to provide continuous power, merely a window period that allows a computer or other user to finalise the work at hand and shut down. It's ability to do this is dependent on the number of devices connected to the UPS.

To establish what you can and cannot connect, calculate the total wattage you need to supply and ensure that the UPS you purchase meets that requirement.

Specifications

Colour: Black

Phase: Single phase with ground

Capacity: 2000 VA / 1600 W

INPUT

Voltage Range

Low Line Transfer: 160 VAC/140 VAC/120 VAC/110 VAC 5% (Ambient Temp. (based on load percentage 100% - 80 % / 80 % - 70 % / 70 - 60 % / 60 % - 0)

Low Line Comeback: 175 VAC /155 VAC/ 135 VAC /125 VAC 5 % (Ambient Temp. (based on load percentage 100% - 80 % / 80 % - 70 % / 70 - 60 % / 60 % - 0)

High Line Transfer: 300 VAC 5 %

High Line Comeback: 290 VAC 5 %

Frequency Range: 40Hz ~ 70 Hz

Power Factor: 0.99 @ nominal voltage

OUTPUT

Output Voltage: 200/208/220/230/240 VAC

AC Voltage Regulation (Batt. Mode): 1%

Frequency Range (Synchronized Range): 47 ~ 53 Hz or 57 ~ 63 Hz

Frequency Range (Batt. Mode): 50 Hz 0.25 Hz or 60Hz 0.3 Hz

Current Crest Ratio: 3:1

Harmonic Distortion: 3 % THD (Linear Load), 6% THD (non-linear load)

Transfer Time

AC Mode to Batt. Mode: Zero

Inverter to Bypass: 4 ms (Typical)

Waveform (Batt. Mode): Pure Sinewave

EFFICIENCY

AC Mode: 89%

Battery Mode: 87%

BATTERY

Battery Type: 12 V / 9 Ah

Numbers: 4

Typical Recharge Time: 4 hours recover to 90% capacity

Charging Voltage: 54.7 VDC 1%

INDICATORS

LCD Panel: UPS status, Load level, Battery level, Input/Output voltage, Discharge timer, and Fault conditions

ALARM

Battery Mode: Sounding every 4 seconds

Low Battery: Sounding every second

Overload: Sounding twice every second

Fault: Continuously sounding

PHYSICAL

Dimension, D x W x H (mm): 397 x 145 x 220

Net Weight (kgs): 17

ENVIRONMENT

Humidity: 20-90 % RH @ 0- 40 C (non-condensing)

Noise Level: Less than 50dB @ 1 Meter

MANAGEMENT

Smart RS-232/USB: Supports Windows 2000/2003/XP/Vista/ 2008, Windows? 7/8, Linux, Unix, and MAC

Optional SNMP (SNMP NETWORK CARD need to be purchased separately): Power management from SNMP manager and web browser

NOTE 1: Derate to 80% of capacity in CVCF mode or when the output voltage is adjusted to 200/208VAC.

NOTE 2: If the UPS is installed or used in a place where the altitude is above than 1000m, the output power must be derated one percent per 100m

What's in the box

1 x UPS Unit

1 x VGA Cable

2 x MALE TO FEMALE EXTENSION POWER CORD IEC C13-C14 (From UPS to PC)

1 x USB Cable (From UPS to PC)

1 x Driver Disk

1 x User Guide

1 x Dedicated Power Cord - Kettle Plug to RED 3 pin (A009)